• Home
  • People
  • Published Papers
  • Conferences
  • Contact/Visit
  • Member Resources
  • Microwave Characterization Laboratory
  • Microelectronics Fabrication Laboratory
  • Teaching Laboratory
  • General Purdue Use
    Microwave Components and Packaging
  • Advanced Packaging
  • Anisotropic Conductive Adhesives
  • Tunable Filters
    Microwave Systems
  • Digital Array Radar
    Integrated Sensors
  • Integrated and Miniaturized Mass Spectrometers

  • Microwave Spectroscopy

  • Biomedically Applied RF
    Past Research
  • Past Reseach Page
  • MTT-S Student Chapter

    VIPER si2T SLA® SYSTEM
    from 3D Systems

    Stereo Lithography Machine

    UV Light Box for curing of fabricated pieces


    SPECIFICATIONS:
    LASER
    Type Solid state Nd:YVO4
    Wavelength 354.7 nm
    Power at vat 100 mW available

    CAPABILITIES
    Build layer capability (z-axis): Minimum - 0.02 mm (0.001 inch)
    Typical - 0.05 mm (0.004 inch)
    Beam (diameter @ 1/e 2 ) Standard mode - 0.250 +/- 0.025 mm (0.010 +/- 0.001 in)
    HR mode - 0.075 +/- 0.015 mm (0.0030 +/- 0.0005 in)

    ELEVATOR
    Vertical resolution 0.025 mm (0.0001 in)
    Position repeatability 0.0076 mm (0.0003 in)
    Maximum part weight 9.1 kg (20 lb)
    Typical velocity during part building 5 mm/sec (0.2 in/sec)

    VAT CAPACITY
    Volume 32.21 L (8.5 U.S. gal)
    Maximum build envelope in Standard mode 250 x 250 x 250 mm XYZ (10 x 10 x 10 in)
    Maximum build envelope in HR mode 125 x 125 x 250 mm XYZ (5 x 5 x 10 in)
    Available vats: Full size and 1/4 size

    BUILD MATERIALS
    Accura SI 10 polymer
    Al2O3loaded monomer suspension

    Copyright 2010 Purdue University
    For any questions or comments about this site, please contanct ideasrf@ecn.purdue.edu